Metering & Power Quality
Collaborate with multiple experts and discuss various topics about Power Meters and Power Quality. From design & implementation to troubleshooting and more, get support from experts and share your experiences by subscribing to the Schneider Electric Exchange forum today.
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Solved
We are excited to announce the launch of our new firmware for some of our Advanced Metering offers.
Firmware version V4.0.0 is now available on se.com for the ION9000, ION7400, and PM8000.
Our latest ...
-->
Discover an optimized power energy monitoring architecture for building energy efficiency and major contents not to miss
What is Metering Power Quality Forum about?
This forum has been...
The Technical Communications Team is committed to making the Advanced Power Meter technical information easier to use and find.
You can help us improve the usability and quality of our content by shar...
Hi everyone,
I would like to ask for your help due to a problem that occurred during the digital input signal test of PM8240.
-CB Status, OCR, and OCGR signals were sequentially connected to the onbo...
Solved
How should a PM8000 meter be configured when used with a split-phase supply where there are only 2 of 3 phases available?
Solved
Hi thereWe are in the process of upgrading the firmware of a number of PM8000 series meters, however on a number of the devices the attached error message comes up when trying to move from the current ...
Solved
Hello,What is the maximum value for Modbus communication regarding THD(V, I)?I understand that the Modbus definition is in FLOAT32 format and the maximum value is 3.402823466 x10^(38).However, I don't ...
Hi All,I am using the PM8000 to capture data (Frequency and kW) pre and post a frequency event. To do this I am using a setpoint module with a limit (for instance 49.97) that triggers a data recorder t...
Hello
would we have something that we can share with customers comparing PM5000 Vs 8000how to explain the power monitoring part of the 8000A how much better it is
see attached, but some meters are ol...
Solved
Hello,
Client has an application where they supply back to utility network.
I managed to demonstrate that output can be switched when customer is delivering (using Q3 setup with DO1).
Here are thing...
Solved
Can you please confirm what is "Current G RMS" value being shown on the webpage of PM8240 meter.
I believe it is Ground fault current value.
what is the formula used to calculate the "Current G RMS" va...
Solved
Hi experts
Good afternoon.
Don't we have DC meters ? I could not find it.
I saw a QA, but it's long time ago.
Some requirements from our client :
Do we have any good suggestions?
Best regards,
Wa...
Solved
The calculated Current Neutral values in our PM710 meters are too high. Which calculation is used for the neutral, is it possible to change this calculation? Turn off this calculation in the meter, is ...
Solved
Hi,I was wondering if it is possible to view the current value(s) in internal registers of a PM8000 through ION Setup.For instance if I have an arithmetic block with two inputs(sources) and one output ...
Subscribing is a smart move!
You can subscribe to this forum after you log in or create your free account.
Create your free account or log in to subscribe to the forum - and gain access to more than 10,000+ support articles along with insights from experts and peers.