Write with command interface in register Powermeter PM3200 in EBO v3.2
EcoStruxure IT forum
A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.
Send a co-worker an invite to the Exchange portal.Just enter their email address and we?ll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Write with command interface in register Powermeter PM3200 in EBO v3.2
Hello everyone
I have a problem
I need a register written with modbus to a series of PM3200 power meters using the COMMAND INTERFACE. the command interface requires a Command Number (Written to Register 5250). So far so good, but in the parameters section I get registered address 5252-5374. I am using Function Code 16.
My question is
Is each record a parameter? How can I configure them correctly? Am I missing a step?
Also, when I read the Command Result register, it tells me 3000 When I put a number in a register in the "Parameters" section (3000 is Invalid command, but the command code is correct according to the manual). If I don't put anything, it tells me 3002 (invalid parameter numbers)
If you can help me, I appreciate it. I am inexperienced using Modbus.