It's your place to connect with experts and peers, get continuous support, and share knowledge.
Contact SchneiderCommunity.Support@se.com if you have any questions.
This was originally posted on APC forums on 2/21/2011Hi There, I have one UPS that sometimes, with low load and beeing connected to mains, does the following: - stops inverter and goes to bypass - lights up fault led - lights up permanently battery l…View more
This was originally posted on APC forums on 6/3/2011I have one UPS that stopped and the LEDs on front panel flashes like this: *= RED LED FAULT + GREEN BATTERY LEDs 3 AND 4 (counting from bottom to up) =* Is there someone who knows to translate this …View more
This was originally posted on APC forums on 7/15/2011I'm trying to put an Network Management Card AP9619 in a SURT3000. To configure it I download Device IP Configuration Wizard software from APC site. I'm using WindowsXT SP3 on my computer. After so…View more
This was originally posted on APC forums on 6/30/2011Hi all Please let me know what happens if I put the Input Phase Selector Switch not in accordance with the power feeding: - Connect the UPS to a three phase mains and put the switch in "1" - Connec…View more
This was originally posted on APC forums on 7/11/2013Hi allThe UPS run well without load.Powering up the UPS with mains at input, connecting some computer load at output - less than 50% full load - after some time it stops running, switches the load …View more
This was originally posted on APC forums on 9/10/2011Hi As in the SUA, is it possible to communicate with the SMT UPSs using Hyper Terminal to gain access to some kind of PROG mode? Message was edited by: dario_ramos
This was originally posted on APC forums on 5/6/2010I have an 1500VA UPS that is noisy when running from batteries and with some kind of loads. It is noisy with computer loads but not with linear loads like lamps. The noise is not continuous. From my…View more
This was originally posted on APC forums on 3/27/2010I have two UPSs with the same problem: trying to do a coldstart, an internal relay operate and de-operates. After this, the fault led lights on and the same does the second and third battery leds. …View more
|Date Last Visited||
2022-08-31 06:30 AM