APC UPS Data Center & Enterprise Solutions Forum
Schneider Electric support forum for our Data Center and Business Power UPS, UPS Accessories, Software, Services, and associated commercial products designed to share knowledge, installation, and configuration.
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Label: "general questions & suggestions"
View in: "APC UPS Data Center & Enterprise Solutions Forum" | Community
240 Posts | First Used: 2021-06-26
We are using Powerchute Network Shutdown version 4.4.0. It is running as a VM appliance on ESX. When I first setup the server, I was able to assign VMs controlled by vCenter to the different priority l...
I finally got a proper UPS in my homelab for my two main servers, my NAS and my Proxmox host (as well as the other core stuff like my cable modem, router, etc.) Altogether, this hardware maxes out arou...
I just received this UPS. This is my first ups that I own. Since the first time that I turned it on, the fans have always been on, and nothing is connected. It's that how is supposed to work? or there'...
What is the best method to be notified when Smart-UPS firmware revision post- 8.3 is released? Are there specific mailing lists to join to be notified on latest releases and release notes?Thank you.
I have my Power Group outlets - power off delay set to 480 seconds. I have a question:- Is there a way to cancel this shut down if the AC power is restored?Thanks!
Hi,Just had a power cut, the 3rd in a few days. Thought it was a good time to buy a UPS for the newcomputer and monitors.PC has has a 5600x and 3080 and I choose a 750w power supply. Monitors are 2 LGs...
I am not sure if this is baseline of this being a non standard IOT device or some issue with agent configuration.My notes from previous UPS setup seem to reflect that I have it setup correctly. My conc...
I am sure this must have been asked before but to get to some specifics quickly, where can i find MiBs for the following models:UPS:MGE Galaxy 3500 20 kVAAP9631CHPDUAP8853(I have NetBotz and ATS switch...
Hello!As shown in the figure, when my PC817 pin 1 is high level, IN5 should be low level normally, but after I tested it, IN5 is still high level completely.How to solve it？Good listening!
I have a Smart-UPS which is connected to a server running PowerChure via a USB cable, and now I would like to replace the server with a new one.Is there any way to move the PowerChute installation with...
Not sure if this is right place for post but I did not see label for vmware PCNS vAPp. I tried to add labels :vmware, PCNS, VM Shutdown, Testing ......... but it did not like them. So I left generic.Bu...
Subscribing is a smart move!
You can subscribe to this forum after you log in or create your free account.
Create your free account or log in to subscribe to the forum - and gain access to more than 10,000+ support articles along with insights from experts and peers.