APC UPS Data Center & Enterprise Solutions Forum
Schneider Electric support forum for our Data Center and Business Power UPS, UPS Accessories, Software, Services, and associated commercial products designed to share knowledge, installation, and configuration.
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Label: "business power ups"
View in: "APC UPS Data Center & Enterprise Solutions Forum" | Community
43 Posts | First Used: 2021-08-03
Anyone have recommendations for lower-cost rack mounted UPS solutions $500 or less? I have 5 servers (80w/each) and a few low power devices (switches, etc) in the rack at the moment. I have APC UPS con...
HI.Randomly I get a low and/or critical output voltage alarm on L1.There is no physical problem i dont believe as if I meaure the outputs there are ok. all around 240V. But L1 output reports 120, 140,1...
Just a few questions regarding the proper setup of my UPS. I purchased the APC Back-Pro 1500VA 900 watt.My r710 has 2 power supplies, is it acceptable to plug one into the battery side and the other in...
Hi,My new APC is powered by three-phase, and sometimes for maintenance, I will need to turn off the main power to discharge the batteries or check the PowerChute shutdown clients.On my last APC SURT100...
Hello everyone,We have a Smart-Ups X 1000 and every 4-5 days the UPS turns itself off. It must therefore be turned on manually via the on/off button.In the log we can see the following messages :2022-0...
I am following these steps to setup RADIUS on this UPS (Network Management Card 3):Tutorial APC UPS - Authentication on the Active Directory [ Step by Step ] (techexpert.tips)The step that defines addi...
Solved
I have an SRT5KRMXLI (APC Smart-UPS On-Line) that the firmware update failed on and now has no web interface. The forum post I followed (which I've now lost) said that the 704 updater was the correct o...
I just received this UPS. This is my first ups that I own. Since the first time that I turned it on, the fans have always been on, and nothing is connected. It's that how is supposed to work? or there'...
Solved
We installed a SRT1500RMXLI-NC just yesterday and I observed a couple of these messages in the logs:05/12/2022 09:11:14 Device UPS: RFC1628 MIB alarm entry removed. 0x3605
05/12/2022 09:11:14 Device UP...
Solved
The server has 2 power supplies. I need to cut power from the APC Smart-UPS for a moment to test the server's failover behavior.. In the PCBE web UI, I can see 'Shutdown Now' with an option for automat...
I have an older UPSdlrtd3000rmxli3u that recently died due to suspected water damage. We have purchased a new APC SmartSRT3000RMXLI. It was connected to the Core Switch via its SmartSlot and had 2 ESXI...
Subscribing is a smart move!
You can subscribe to this forum after you log in or create your free account.
Create your free account or log in to subscribe to the forum - and gain access to more than 10,000+ support articles along with insights from experts and peers.