Discovering Smart-UPS in the Gateway

Notifications

Gateway software installation and setup

Step-by step instructions for how to download, install, and set up the EcoStruxure IT Gateway

Invite a Co-worker

Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.

Send Invite Cancel

Related Forums

Previous Next

Invite a Colleague

Found this content useful? Share it with a Colleague!

Invite a Colleague

Contact Support

Submit a support request for additional assistance with EcoStruxure IT software.

Request Support

Back to Gateway software installation and setup

1682 Views

Link copied. Please paste this link to share this article on your social media post.

Trying to translate this page to your language?

Select your language from the translate dropdown in the upper right.

Translate to: English

Discovering Smart-UPS using a Network Management Card (NMC)

If the Smart-UPS connects to your network using a Network Management Card (NMC), you can discover it in the EcoStruxure IT Gateway using SNMPv1 or SNMPv3.

Do not use the ethernet port on the UPS to connect to EcoStruxure IT if the UPS uses an NMC.

Discovering Smart-UPS via Modbus

Smart-UPS models starting with SMT, SMTL750, and SMTL1000 support Modbus TCP using the ethernet port on the UPS with firmware version 4.2 and greater.

NOTE: Modbus TCP discoveries are supported on EcoStruxure IT Gateway version 1.9.0 and newer.

See Installing and setting up EcoStruxure IT Gateway

Didn't find what you are looking for? Ask our Experts

To The Top!

Discovering Smart-UPS in the Gateway

Related Forums

EcoStruxure IT forum

APC UPS Data Center & Enterprise Solutions Forum