Schneider Electric support forum about Power Meters (ION, PowerTag, PowerLogic) and Power Quality from design, implementation to troubleshooting and more.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
2022-05-1612:20 AM
mA to A measurement display of PM5000 (PM5350P)
Hello.
I do not know why I am so confused about this when it should be trivial (and the user guide is not clear about measured values).
We would like to have the PM5350P show current value in A and not mA. Why does it show in mA? I played with CT primary and seconday. At 1200 primary and 5 secondary, it should show A, am I correct? Is it dependent upon the load? At what load does it change to A?