Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84597members
353864posts

mA to A measurement display of PM5000 (PM5350P)

Metering & Power Quality

Collaborate with multiple experts and discuss various topics about Power Meters and Power Quality. From design & implementation to troubleshooting and more, get support from experts and share your experiences by subscribing to the Schneider Electric Exchange forum today.

Yarom
Crewman Crewman
Crewman
0 Likes
0
184

mA to A measurement display of PM5000 (PM5350P)

Hello.

 

I do not know why I am so confused about this when it should be trivial (and the user guide is not clear about measured values).

 

We would like to have the PM5350P show current value in A and not mA. Why does it show in mA?  I played with CT primary and seconday. At 1200 primary and 5 secondary, it should show A, am I correct? Is it dependent upon the load? At what load does it change to A?

 

Thanks,

 

Yarom

Tags (1)