It's your place to connect with experts and peers, get continuous support, and share knowledge.
Contact SchneiderCommunity.Support@se.com if you have any questions.
My male-female extension cable for the TM171ADMI programmer got caught in a panel door and got broken. I am considering replacing it with a multi-port USB extender to enhance my laptop´s USB ports. Is it ok or it is better to keep it assigned to only…View more
Is it possible to save a STRING in EEPROM ?. I figure I could use some self defined table and assign A = 0001 B = 0010 C = 0011 etc... so I think I could save at least 5 chars (letters) in a UDINT. I have downloaded the StrLib but it only works fr…View more
I get this kind of errors when running a simulation from time to time. PLC EXECUTION ERROR: Fault in task Timed, exception 0xC0000005 at 0x6220F30 Simulation session stops and the second to last sign on the right bottom of the screen changes from a g…View more
I was reprogramming a TM172PDG28R a while ago. after changing the polarity of an input. So I did as always and I was not paying much attention to the whole process. However after restarting I got this: System Fault WDT : 3 I had run into this issue o…View more
I found looking at the TDA_Chiller_Simple project that it is possible to show UDINT units with the TM171 display by using a format named "h" which I assume is configurable somehow. I could not find the information on how to create a new display unit,…View more
what is the right way to use S (SET) and R (Reset) in HAVC ecostruxure machine expert ? bool1 S= bool2 ; does not work, it gives syntax error.
I would not like to invent gunpowder again if I can help it ... Is there a standard way to show a date on screen with TM171 ? Anything that would look similar to the way we change RTC showing Hour and date afterwards ? https://www.youtube.com/watch?v…View more
I have not used Mux until recently, but I am starting to do it. It can save lots of time when used properly ! For example, in the project for multiple displays uploaded by Federico yesterday: ProbeDisplayed := MUX(currentview,probeAI1,probeAI2, probe…View more
I forgot to correctly set some of the input types (CL00/01/02/03/04) in a TM171 so I implemented the SmartBaseGetAiType available in the SmartBios library. AiCfg_usiType := SmartBaseGetAiType(0); works fine in a real target but hangs the simulator. I…View more
I would like to be able to quickly see several variables of a chiller on the display of a TM171, so I have defined a variable I call iDisplay which is type INT and has no units. Then I define a local key to cycle through the different variables I nee…View more
|Date Last Visited||
5 hours ago