Solved
Go to Solution
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Link copied. Please paste this link to share this article on your social media post.
2024-10-22
06:58 AM
I have been scratching my head for hours.... where is the programming button on the mtn6215-5910 multitouch?
When I connect it to the KNX bus it just says Not Configured
Labels
- Labels:
-
SpaceLogic devices
Accepted Solutions
1
262
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Link copied. Please paste this link to share this article on your social media post.
2024-10-23
06:19 AM
Replies 2
1
263
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Link copied. Please paste this link to share this article on your social media post.
0
238
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Link copied. Please paste this link to share this article on your social media post.
2024-10-23
11:46 AM
Doh ! Thank you - I had not realised it was a button. I assumed it was a sensor.

