Metering & Power Quality
Schneider Electric support forum about Power Meters (ION, PowerTag, PowerLogic) and Power Quality from design, implementation to troubleshooting and more.
Link copied. Please paste this link to share this article on your social media post.
Hello. Has anyone had experience integrating SEL relays or RTAC into PME? Can they be set up to look and act like a power measurement meter, PMxxxx? Is there an add-on driver for this?
or do you have to use an actual PMxxxx meter and configure modbus (or other) comms to poll the data into the PMxxxx meter first?
Thanks,
Warren
Link copied. Please paste this link to share this article on your social media post.
@whumphrey have you tried access the PME forum before, https://community.se.com/t5/EcoStruxure-Power-Monitoring/bd-p/power-monitoring-expert?
Link copied. Please paste this link to share this article on your social media post.
Hello @whumphrey ,
PME has its own forum. This question does not below in Hardware metering forum. @Kevin_Huang do you know who Whumphrey needs to contact to get access to PME forum?
Regards,
Charles
Link copied. Please paste this link to share this article on your social media post.
@whumphrey have you tried access the PME forum before, https://community.se.com/t5/EcoStruxure-Power-Monitoring/bd-p/power-monitoring-expert?
Link copied. Please paste this link to share this article on your social media post.
Hi Kevin. Thank you. When I try the PME forum link I get Access Denied. I'll follow the support email link to request access but if you know of a better way, please advise. Thanks!
Link copied. Please paste this link to share this article on your social media post.
Hi @whumphrey ,
I am also trying to do the same thing as you are, if you were able to
"Has anyone had experience integrating SEL relays or RTAC into PME? Can they be set up to look and act like a power measurement meter, PMxxxx? Is there an add-on driver for this?
or do you have to use an actual PMxxxx meter and configure modbus (or other) comms to poll the data into the PMxxxx meter first? "
Can you help me troublesoot this issue?
Link copied. Please paste this link to share this article on your social media post.
Hello @kedar.bhatt,
This question should be asked in the PME forum at the link given by Kevin. I am not sure if there is a factory made driver for SEL devices. The PME forum has a supported device matrix indicating if there is a factory created driver or not. If no driver exists, it is possible to use the Device Type Editor (DTE) to create a driver if the SEL device supports modbus. Please refer to the PME system guide for more information on the DTE.
Regards,
Charles
Link copied. Please paste this link to share this article on your social media post.
Tienes que crear un medidor con el mapa modbus del SEL que quieres implementar en el PME , normalmente si solo lo requieres como medidor de potencia solo agrega los datos mas comunes
V1 V2 V3 , I1,I2,I3 , Potencias y energías asi solo usas al rededor de 15 a 20 registros . Esto se hace desde Management Consolé/editor de tipo de dispositivo
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.