How to setup and configure ION8650 to send alert (voltage disturbance detection) to handphone via short text messages

[Parlindungan_Sitorus]

Hi Expert,

I kindly need advice how to setup and configure the ION8650, when there is a sag/swell (voltage disturbance detection), will send notification to user via SMS (short text message) to user's handphone?

Is there any device/interface needed to make this scenario happen?

[Tom_Stevenson · Accepted solution]

Hi Parlindungan

I don't know your exact requirements, but this should hopefully get you going - if you are wanting to alert on any Sag/Swell, you could link the "Record Complete" pulse output of the Sag/Swell Log to a new Alert Module (see attached picture) and configure the Alert Module to send an email that routes to the SMS recipient.  Details on the configuration of Alert can be found in the ION Reference (ION Reference Home (se.com)).

I hope this gets you going!

Tom

[Charles_Murison]

Hello @Parlindungan_Sitorus ,

To extend what Tom as said, it is possible to add some context to the alert from inputs linked to the alert module. ION reference is a great resource on how to do this.

Regards,

Charles