It's your place to connect with experts and peers, get continuous support, and share knowledge.
This was originally posted on APC forums on 11/24/2015I have recently acquired a AP9619 NMC that does not respond to the typical password reset protocol. I can access the card using "device" username and "apc" password. However, I cannot log in as ad…View more
Posted by: MarkC_apc in APC UPS Data Center Backup Solutions Forum
This was originally posted on APC forums on 2/19/2016I used the following steps to repair a ribbon cable that had been ripped from the control panel circuit board; 1. Cut the torn end of the cable square. Be careful not to remove so much that the cab…View more
Posted by: MarkC_apc in APC UPS Data Center Backup Solutions Forum
Find more articles tagged with:
This was originally posted on APC forums on 8/17/2015This is a follow-up of a post that I started several months ago (same title) requesting any experience with this excellent UPS having an "internal fault" message on the LCD screen, yet the unit wor…View more
Posted by: MarkC_apc in APC UPS Data Center Backup Solutions Forum
This was originally posted on APC forums on 7/30/2015Installing a AP9619 NMC in this unit using the serial communications to configure the IP address. The serial configuration required to communicate was 9600 baud. This was a surprise as I expected 2…View more
Posted by: MarkC_apc in APC UPS Data Center Backup Solutions Forum
This was originally posted on APC forums on 7/4/2015Anyone know if this model ups provides any significant surge protection (in addition to backup power)?
Posted by: MarkC_apc in APC UPS Data Center Backup Solutions Forum
This was originally posted on APC forums on 6/16/2015Is it possible to capture data directly to a spreadsheet from the NMC on a Smart UPS? It would need to be in a format that could be mathmatically uitilized by the spreadsheet functions. Thanks, Mar…View more
Posted by: MarkC_apc in APC UPS Data Center Backup Solutions Forum
This was originally posted on APC forums on 6/5/2015Tthe serial connection only works (with hyperterminal) while the NMC is installed. This is a 2011 unit and the NMC appears to have the original software interface (not upgraded). I do have to "exit"…View more
Posted by: MarkC_apc in APC UPS Data Center Backup Solutions Forum
This was originally posted on APC forums on 5/14/2015Trying to track down the cause of the LCD message "internal fault" The UPS works under full control of the NMC2. All menu items work perfectly EXCEPT when I try to do a battery calibration test, it…View more
Posted by: MarkC_apc in APC UPS Data Center Backup Solutions Forum
Find more articles tagged with:
This was originally posted on APC forums on 12/14/2015Anyone have the following information on this UPS? - What is the "idle" wattage that this unit draws with no output load when connect to mains - Any estimates of wattage draw on batteries with on …View more
Posted by: MarkC_apc in APC UPS Data Center Backup Solutions Forum
This was originally posted on APC forums on 2/1/2016Couple of questions; 1. Can a new LCD screen be purchased with the ribbon cable and the wire connector? If so, how to do that? 2. Are there any differences in the LCD screens for the SMX and SMT UPS…View more
Posted by: MarkC_apc in APC UPS Data Center Backup Solutions Forum