SMX3000 Internal fault message

Notifications

APC UPS Data Center & Enterprise Solutions Forum

Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.

Invite a Co-worker

Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.

Send Invite Cancel

Top Experts

User

Count

5060

196

112

108

Invite a Colleague

Found this content useful? Share it with a Colleague!

Invite a Colleague

Back to APC UPS Data Center & Enterprise Solutions Forum

685

Link copied. Please paste this link to share this article on your social media post.

This is a follow-up of a post that I started several months ago (same title) requesting any experience with this excellent UPS having an "internal fault" message on the LCD screen, yet the unit worked fine in all respects being controlled through the NMC2 card. Recently, after removing the NMC's "cage" to gain access to the microprocessor area and doing a little "probing", it was necessary to re-install the NMC to test a new router/D-Link repeater set up. Upon startup of the UPS, the LCD screen now works as originally intended with full menu control.

If anyone has had any type of similar experience with the SMX line, please post a reply.

P.S. "probing" is not recommended by the manufacturers and is done at your own peril of damage to equipment and yourself!

Replies 0

To The Top!