- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Link copied. Please paste this link to share this article on your social media post.
Hi Is it possible to use SpacelYnk as a KNX IP / Modbus RTU Gateway, where the SpacelYnk is a master and the Micom C264 (is a Slave) see image below
is there any Aplication center where I can buy a service for configuring/Programming the SpacelYnk ?
Thx
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Link copied. Please paste this link to share this article on your social media post.
Dear Mahmoud,
Yes it is possible, all what you need is registers table for Micom device.
I am not sure if there is such an application centre, but you can contact Aitor Martinez, describe what business is behind this solution and he can manage next progress.
BR
David
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Link copied. Please paste this link to share this article on your social media post.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Link copied. Please paste this link to share this article on your social media post.
Dear Mahmoud,
is this topic solved/answered? If "Yes" please mark it accordingly.
Kind regards
Thomas
Thomas
Application Design Engineer