Subscribing is a smart move!
You can subscribe to this board after you log in or create your free account.
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Link copied. Please paste this link to share this article on your social media post.
Hi.
I see that on mobile app the data reported from sensor controlled by a Netbotz appliance disply only the pod name but some sensor are not connected directly to the Netbotz but could be controlled via SNMP or IPMI protocol. So in mobile app I see a lot of sensor data but I cannot understand correct sensor reference, for example I see battery age or battery voltage but I know that it referred to an UPS, but label of UPS is not displayed. For example this is what I see on NetBotz Advance View configuration:
and this the correspondance on mobile APP:
I aspect that instead appear Office_CED under Battery Age on mobile app the correct label must be APC04.
in the past app release this is displayed correctly.
Regards.
Link copied. Please paste this link to share this article on your social media post.
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.