NBES0307 smoke sensor question

[DCIM_Support]

Hi 

when will the sensor detects the smoke status?  Any threshold pre-configured in the sensor?  If so , what’s that? 

(CID:126883991)

[DCIM_Support]

Hi Annie,

I just hooked up a smoke sensor to a 450 and it gets detected but I don't see a threshold when I go to "configure pod". The only thresholds you can set however are based on state. The smoke sensor either detects smoke or does not and you can't set a threshold based on how much smoke it detects. It's like a door sensor, there's no almost closed state, it's open or closed.

I find no documentation on how much smoke will cause the sensor to trigger. 

Steve

(CID:126884140)

[DCIM_Support]

Hi all,

Product management came up with the numbers and that along with the datasheet are now available in k-base:

http://www.apc.com/us/en/faqs/index?page=content&id=FA335679

Thanks,

Steve

(CID:126884863)

[DCIM_Support]

Hello Annie,

I also have same question with you and I fonud some document for your reference ,

Hope it usefully for you ,thank you .

Best Regards

(CID:126884716)

[DCIM_Support]

I instilled a series of netbotz 250 in several backstage APC, the problem is that in some of them the temperature/humidity sensor dont appear on display. what i can do do solve this issue?

(CID:126885526)

[DCIM_Support]

Wrong post. This is being addressed on the following post:

Steve 

(CID:126885579)

[DCIM_Support]

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.