Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84323members
353487posts

How to use Device IP Configuration Wizard

EcoStruxure IT forum

A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.

DCIM_Support
Picard
Picard
0 Likes
2
320

How to use Device IP Configuration Wizard

This question was originally posted on DCIM Support by tanawat on 2020-01-14


Can I use Device IP Configuration Wizard to search MAC Address for assign IP by connect many NMC2 to switch and search at once?

(CID:153553639)

2 Replies 2
DCIM_Support
Picard
Picard
0 Likes
0
320

Re: How to use Device IP Configuration Wizard

This answer was originally posted on DCIM Support by spezialist on 2020-01-14


Dear tanawat,

Yes, of course you can, this has the advantage of this utility. The main thing is that there should not be routers between your PC and APC devices.

With respect.

(CID:153553660)

DCIM_Support
Picard
Picard
0 Likes
0
320

🔒 Closed

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.