Smart UPS RT 3000VA (SURTD3000RMXLI)

BillP · ‎2021-06-27

This question was originally posted by PAOLO on APC forums on 1/24/2015

Hi,

I've just replaced the battery pack of my APC SURTD3000RMXLI because they are at the end of life (5 Years)

Now I've a problem with my SURT . Right LEDS are blinking and the PowerChute is still claiming that the UPS has no

sufficient runtime available (0 Minutes and the battery are 100% charged) I don't know if my UPS is damaged or not,

but I will be very happy if someone help me in the troubleshooting. Thanks.

BillP · ‎2021-06-27

This reply was originally posted by Angela on APC forums on 1/26/2015

Here is a knowledge base on what this symptom means - I'd suggest you proceed with a runtime calibration to start (after reviewing the article) unless at the same time you changed the batteries, you adjusted settings which could also be a cause.

Why are the battery charge LEDs flashing on a Smart-UPS? http://www.apc.com/support/index?page=content&country=ITB〈=en&locale=en_US&id=FA156538

See Answer In Context

BillP · ‎2021-06-27

This reply was originally posted by Angela on APC forums on 1/26/2015

Here is a knowledge base on what this symptom means - I'd suggest you proceed with a runtime calibration to start (after reviewing the article) unless at the same time you changed the batteries, you adjusted settings which could also be a cause.

Why are the battery charge LEDs flashing on a Smart-UPS? http://www.apc.com/support/index?page=content&country=ITB〈=en&locale=en_US&id=FA156538