We Value Your Feedback!
Could you please spare a few minutes to share your thoughts on
Cloud Connected vs On-Premise Services. Your feedback can
help us shape the future of services. Learn more about the survey
or
Click here to Launch the survey Schneider Electric Services Innovation Team!
Calibration problem on Smart-UPS SMT1500I
APC UPS Data Center & Enterprise Solutions Forum
Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-3008:14 AM. Last Modified: 2024-03-0703:20 AM
Calibration problem on Smart-UPS SMT1500I
Hello everyone,
My company bought last year 1 SMT1500I and May this year another 5 pieces.
Today I decided to run a "Runtime Calibration" on all six UPS-s.
I've putted an 400W heater as a load and started the calibration.
On the UPS that we bought last year the calibration ran fine. The calibration ran for about 40 minutes.
When I tried to run the "Runtime Calibration" on the UPS-s that we bought in May I observed that it runs for only 3-4 minutes than it says "Passed" and ens.
Is it ok for the "Runtime Calibration" to run only 3-4 minutes?