Schneider Electric support forum for our Data Center and Business Power UPS, UPS Accessories, Software, Services, and associated commercial products designed to share knowledge, installation, and configuration.
Posted: 2021-07-01 01:48 AM
This was originally posted on APC forums on 11/1/2012
I did setup UPS APC Smart-UPS RT 10,000VA RM 230V and connected the servers to UPS already, now i need to setup IP for SNMP card, when i set IP need reboot as below:
E002: Success
Reboot required for change to take effect.
If i enter the reboot command, the UPS lost power to server and the server will off ?
I cannot turn off server now, but i need change IP of SNMP card, give me an advice
Regards,
Minh
Posted: 2021-07-01 01:48 AM
This reply was originally posted by Angela on APC forums on 11/1/2012
please refer to Referenced content removed
Posted: 2021-07-01 01:48 AM
This reply was originally posted by Angela on APC forums on 11/1/2012
please refer to Referenced content removed
Create your free account or log in to subscribe to the forum - and gain access to more than 10,000+ support articles along with insights from experts and peers.