AP9631 need reboot

[Anonymous user]

I did setup UPS APC Smart-UPS RT 10,000VA RM 230V and connected the servers to UPS already, now i need to setup IP for SNMP card, when i set IP need reboot as below:

E002: Success
Reboot required for change to take effect.

If i enter the reboot command, the UPS lost power to server and the server will off ?
I cannot turn off server now, but i need change IP of SNMP card, give me an advice
Regards,
Minh

[BillP · Accepted solution]

please refer to Referenced content removed