SpaceLogic KNX Forum
Schneider Electric SpaceLogic KNX forum to get support and share knowledge including selection, installation and troubleshooting for spaceLYnk, Wiser for KNX, eConfigure KNX, SpaceLogic KNX Hybrid module and other topics.
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Hello Abdulrhman23
Error 0040 indicates a problem with the analogue input which is the connector where you could connect an external temperature sensor. Seems the product is defective.
Is the device new or older? It indicates firmware 30.7, did it come with this firmware or was the device updated?
Link copied. Please paste this link to share this article on your social media post.
hello dear
The device is new
It was working and suddenly this happened to it
Link copied. Please paste this link to share this article on your social media post.
Can You connect MT To any Laptop using USB cable then remove it and connect it to bus and try to full Download
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.