Technical Problem Occurred in PM8240 when an Automation Server

Notifications

Metering & Power Quality

Schneider Electric support forum about Power Meters (ION, PowerTag, PowerLogic) and Power Quality from design, implementation to troubleshooting and more.

Important Note

Invite a Co-worker

Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.

Send Invite Cancel

Top Experts

User

Count

456

110

Invite a Colleague

Found this content useful? Share it with a Colleague!

Invite a Colleague

Back to Metering & Power Quality

462

Link copied. Please paste this link to share this article on your social media post.

Dear Sirs

We found a technical problem in PM8240 when using an Automation Server (product of Struxureware Building Operation) to poll PM8240 meter. The PM8240 meter went power down and then power up (like a power reset) every time when changing the communication setting such as polling rate or AS's device ID in Automation Server. However, the ION7650 meter had no such problem when changing the same in Automation Server. There was no error event (prority 255) be recorded in PME7.2.

Please advise how to solve the problem occurred in PM8240.