PM8240 and PM5110: Modbus Points for Meter Powerup and Meter Normal / Failure

Notifications

Metering & Power Quality

Schneider Electric support forum about Power Meters (ION, PowerTag, PowerLogic) and Power Quality from design, implementation to troubleshooting and more.

Invite a Co-worker

Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.

Send Invite Cancel

Top Experts

User

Count

403

Invite a Colleague

Found this content useful? Share it with a Colleague!

Invite a Colleague

Back to Metering & Power Quality

477

Link copied. Please paste this link to share this article on your social media post.

Dear All

We have a project in Hong Kong that a SCADA requires the following points from PM8240 and PM5110 meters.

1. Meter power on

2. Meter normal / failure

For PM5110, should we use the points of Meter Powerup (Control Power Loss) [register: 13623] and Meter Diagnostic [register: 13625 ] for meter power on and meter normal respectively? What will the output for these two points, e.g. Meter Diagnostic = 1 is normal, Meter Diagnostic = 0 is failure?

For PM8240, should we use the points BIST in the Diagnostic module as meter normal / failure? But we have no ideal about the points of meter Powerup which needs your advice.