Schneider Electric support forum about Power Meters (ION, PowerTag, PowerLogic) and Power Quality from design, implementation to troubleshooting and more.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
2015-01-0509:05 PM
PM 820 Harmonics
Good afternoon all.
Upon looking at some values from one of our Portable PM820's that just came back from a client's site, I noticed some erroneous current THD readings:
I'm aware that anything below 1 ampere will have a multiplying affect on harmonics, but this is not the case here. Also, please note how the values (current) before and after the boxed value are very similar, and yet the % of THD is almost 40% different. Any explanations on how this could be above 100% would be fantastic.