new genome library

[DCIM_Support]

Using DCO8.1 how would I apply a new genome library release?

thank you.

(CID:128758342)

[DCIM_Support · Accepted solution]

Dear Altair Engineering IT Systems,

See the answer to your question in topic Genome library update:

You only need to apply the latest version (it contains the updates).

I.e., you only need to download the latest Genome Library from "Genome library download" (page link may not be shared here!), since it is fully compatible with your DCO-8.1:

With respect.

(CID:128758397)

[DCIM_Support]

thank you. I was looking for the instructions, I already downloaded the zip file.

(CID:128758408)

[DCIM_Support]

Dear Altair Engineering IT Systems,

The above instruction is simply below (under the Downloads section) on the page I have already specified Genome Library download page:

I hope this is what you need 😀.

With respect.

(CID:128758429)

[DCIM_Support]

thank you, it was not obvious that one has to scroll to the bottom of the page. I think this page should be redesigned.

(CID:128758481)

[DCIM_Support]

Dear Altair Engineering IT Systems,

Your recommendations have followed (by Schneider Electric), so see the updated page Genome Library download.

With respect.

(CID:128758835)

[DCIM_Support]

Very well done, appreciate your quick response.

Best regards.

(CID:128758840)

[DCIM_Support]

Ok, thanks for the feedback 😀.

(CID:128758846)

[DCIM_Support]

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.