EcoStruxure IT forum
A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.
Posted: 2020-07-05 02:36 PM
This question was originally posted on DCIM Support by Eva on 2018-11-27
Is anyone know DEC 7.5.0 can accept the format of SNMP v1 form Net Vision communication card and is running normally?
(CID:137104356)
Posted: 2020-07-05 02:36 PM
This answer was originally posted on DCIM Support by spezialist on 2018-11-27
Dear Eva,
Of course yes: DCE software uses the industry standard SNMP v1, v2c and v3 protocol to read sensors of the SNMP enabled devices.
With respect.
(CID:137104413)
Posted: 2020-07-05 02:36 PM
This comment was originally posted on DCIM Support by Andrew Stoakes on 2018-11-27
It has limited information but you can read SNMP v1. You can also create custom OID that will be displayed if you need aditional information.
(CID:137104799)
Posted: 2020-07-05 02:36 PM
This comment was originally posted on DCIM Support by spezialist on 2018-12-09
Dear Eva,
Tell us please, did you solve this question or not?
With respect.
(CID:137109243)
Posted: 2020-07-05 02:36 PM
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
Create your free account or log in to subscribe to the forum - and gain access to more than 10,000+ support articles along with insights from experts and peers.