Schneider Power Meter PM8000 SNMP DDF issues

[DCIM_Support]

Hi

We have seen some issues with PM8000 SNMP DDF:

1-Data Center Exper value " Label" don't show the device name , other values are correct.

2-Data Center Expert  sensor value "Power factor" is negative but  the device power factor value is positive

3- It is posible to add  power quality values to the DDF:

THD Voltage

V1 THD 3s (%)

V2 THD 3s (%)

V3 THD 3s (%)

THD Current

I1 THD 3s (%)

I2 THD 3s (%)

I3 THD 3s (%)

I4 THD 3s (%)

I1 K   Factor

I2 K   Factor

I3 K   Factor

I4 K   Factor

I1 Crest   Factor

I2 Crest   Factor

I3 Crest   Factor

I4 Crest   Factor

 Thanks in advance for the help

Regards

(CID:148343468)

[DCIM_Support]

Hi Sergio,

Thanks for reporting this.  Would you mind reporting this issue on the DDF page?  You can find it here:  DDF download.  It forces you to first search, but as soon as you do, you can click the "Request" button.  This will create a ticket for the DDF team.

Thanks,

Jake

(CID:148343845)

[DCIM_Support]

Hi Jake, thanks for the answer , I proceed as you indicate.

Regards

(CID:148343961)

[DCIM_Support]

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.