How can I make a new conector for door switch sensor NBES0312?
EcoStruxure IT forum
Schneider Electric support forum about installation and configuration for DCIM including EcoStruxure IT Expert, IT Advisor, Data Center Expert, and NetBotz
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: β2020-07-0307:46 AM. Last Modified: β2024-04-0804:05 AM
Hi Pablo,
Sorry but we have no wiring diagrams / pinouts to give out. If the cable is broken anywhere other than at the RJ45 end, you can simply strip the wire and reconnect the like colors.