Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84292members
353414posts

Getting SHA-256 from NetBotz 250

EcoStruxure IT forum

A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.

DCIM_Support
Picard
Picard
0 Likes
2
284

Getting SHA-256 from NetBotz 250

This question was originally posted on DCIM Support by Raphael FLAMENBAUM on 2019-11-13


Hello every one,

I am currently working on the Rack Monitor Netbotz 250.

I would like to know if it is possible to ask the Rack Monitor to compute the SHA-256 or use any other integrity check means to know the integrity of every firmware of configuration the Rack Monitor has.

I am looking forward reading from you.

Best Regards,

rf2019

(CID:151065211)

Tags (1)
2 Replies 2
DCIM_Support
Picard
Picard
0 Likes
0
284

Re: Getting SHA-256 from NetBotz 250

This comment was originally posted on DCIM Support by Raphael FLAMENBAUM on 2019-12-17


Hi every one,

Does the community have answer regarding this topic ? I am still struggling on this aspect.

Best Regards,

 

rf2019

(CID:152570661)

DCIM_Support
Picard
Picard
0 Likes
0
284

🔒 Closed

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.