Connecting devices with NO/NC dry contact to DCE AP9465 Server

[DCIM_Support]

Hi,

In one of our projects, client wants to connect below devices with NO/NC dry contacts to DCE AP9465 Server:

1. Fuel Tank
2. Generator 1
3. Generator 2
4. Main Gate DSM "Door status monitor"

I understand that we have modbus rs485 to tcp/ip converter (TSXETG100) but for the above can anyone suggest a device.. may be a third party device which was tested and working?

Thanks & Regards

Shemil

(CID:110012070)

[DCIM_Support]

Hi Shemil,

You can easily use Schneider Automation Server for such requirements which can again hook back to SXW DCE. See my post here:

(CID:110012075)

[DCIM_Support · Accepted solution]

Hi Shemil, you can also use the Netbotz 250 (NBRK0250) in combination with the dry contact cables, connected to the Universal sensor ports

Used for connecting APC sensors and third-party dry contact sensors. (See “Connect
sensors to universal sensor ports” on page 12 for a list of applicable APC sensors.) Thirdparty
dry contact sensors require a NetBotz Dry Contact Cable (NBES0304).

This Netbotz can be connected to you're generator via the dry contact cables and the netbotz itself can then be monitored via the DCE

(CID:110012130)

[DCIM_Support]

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.