ATS AP7723 does not prevent attached devices to reboot

[DCIM_Support]

User of ATS AP7723, source A is directly connected to the provider power supply and source B is connected to an APC UPS. When loosing source A, automatic switch is performed. However the attached devices reboot involving from my point of view the a micro loss of power supply meanwhile switching from source A to source B. Log file of ATS mentions fault detection on both source (A and then B). Any help to understand this unexpected behavior is welcome.

(CID:122692946)

[DCIM_Support]

Herve,

I would recommend posting ATS related questions on the APC forum at: http://forums.apc.com.

Regards,
Cory 

(CID:123342729)

[DCIM_Support]

OK. I will.

(CID:123342733)

[DCIM_Support]

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.