SPD and Gateway install in Acti9 Isobar P board.

[owensr]

Is it possible to install in an Acti9 Isobar P board an SPD device and the EcoStruxure Panel Server?

I can see from the instructions that both normally install on the DIN bar next to the incoming Switch. But is it possible to install both in one board?

If not guess you could put the Surge Protection Device in a secondary board mounted next to the primary but this feels a bit overkill. But I can't see any other way of doing it?

Note this is for a 3 phase installation.

[Thierry_Baudard]

Hello,

this forum is dedicated to question relative to Energy Hub Cloud platform . for mechanical question relative to installation of material in enclosure (in your case Panel Server in Acti9 isobar) , I advise you to create a support ticket for the Customer  Center or to contact your SE front office for help.