Unable to load SSL certificate after SUMX 6.4.0 update

Notifications

APC UPS Data Center & Enterprise Solutions Forum

Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.

Invite a Co-worker

Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.

Send Invite Cancel

Top Experts

User

Count

5060

196

112

108

Invite a Colleague

Found this content useful? Share it with a Colleague!

Invite a Colleague

Back to APC UPS Data Center & Enterprise Solutions Forum

401

Link copied. Please paste this link to share this article on your social media post.

I have several Network Management Cards in Smart UPS' which were working fine. They were on version 6.2.1 and SSL certificates I had created were installed. On pushing the 6.4.0 firmware update from DCE, i noticed that a self generated SSL certificate is now in place on all updated units. When I use the Add or Replace certificate function to put the old one back in, I get "Loading Certificate" but it never (2+ hours) does.

I have tried re-creating new certificates in 1024 and 2048 flavours but to no avail.

Help greatly appreciated

Replies 0

To The Top!