Ask Me About Webinar: Data Center Assets - Modeling, Cooling, and CFD Simulation Join our 30-minute expert session on July 10, 2025 (9:00 AM & 5:00 PM CET), to explore Digital Twins, cooling simulations, and IT infrastructure modeling. Learn how to boost resiliency and plan power capacity effectively.Register now to secure your spot!
SURTD3000XLI
APC UPS Data Center & Enterprise Solutions Forum
Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-3008:51 PM. Last Modified: 2024-03-0712:12 AM
SURTD3000XLI
I have SURTD3000XLI smart apc ups. The battery was faulty and changed to brand new. i on the ups it started showing one red light and one battery ball.please see the attachment below
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-3008:51 PM. Last Modified: 2024-03-0712:12 AM
Your control panel is showing a fault code (the red light above the "X"). The code that it is showing is related to the inverter section. There is no "auto recovery" from this state. You can try "brain dead" and "cold starts", but likely will need to be repaired/replaced. Your Schneider tech must help at this point.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-3008:51 PM. Last Modified: 2024-03-0712:12 AM
Your control panel is showing a fault code (the red light above the "X"). The code that it is showing is related to the inverter section. There is no "auto recovery" from this state. You can try "brain dead" and "cold starts", but likely will need to be repaired/replaced. Your Schneider tech must help at this point.
This is a heading
With achievable small steps, users progress and continually feel satisfaction in task accomplishment.
Usetiful Onboarding Checklist remembers the progress of every user, allowing them to take bite-sized journeys and continue where they left.