SUA3000RMI2U turned off during a run time calibration
APC UPS Data Center & Enterprise Solutions Forum
Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-3008:18 PM. Last Modified: 2024-03-0712:28 AM
SUA3000RMI2U turned off during a run time calibration
Hello,
I found the problem with my ups: It was turned off during runtime calibration, now its dead, no light, no beep, no output.. APC says this should not be done in no circumstances. Can this be reset? Its not accessible via usb. Would it help to change the Eeprom chip if nothing else works?