Replacing Battery APC 1500 Rack Mount and Disconnecting

Notifications

APC UPS Data Center & Enterprise Solutions Forum

Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.

Invite a Co-worker

Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.

Send Invite Cancel

Top Experts

User

Count

5060

196

112

108

Invite a Colleague

Found this content useful? Share it with a Colleague!

Invite a Colleague

Back to APC UPS Data Center & Enterprise Solutions Forum

667

Link copied. Please paste this link to share this article on your social media post.

Hello All. I have some 1500 rack mount APCs that are reporting "At least one fault battery exists." I'm going to order some replacements, but have a couple of additional questions.

In the meantime while waiting for the replacement batteries, is it okay to disconnect the battery plug from the UPS?

I've removed these batteries before on past UPS and the adhesive can make it very difficult to remove the battery. I've gone at it from the bottom of the tray and prying out from the side of the battery. Does anyone know of a good method that usually doesn't leave the existing battery shaved or dented? Thanks.

Replies 0

To The Top!