Subscribing is a smart move!
You can subscribe to this board after you log in or create your free account.
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Solved
Go to Solution
Link copied. Please paste this link to share this article on your social media post.
Good Morning APC Forum 🙂
Newbie here. I'm Dale, just started a Junior Network Engineers post so please forgive me if I miss something or get a little mixed up. Still very new to all of this.
I have received 18000 emails since the early hours from multiple UPS' on site that are stating that they are "Compensating for a high input voltage." We have turned off the notifications for Voltage Input but still receive emails. These UPS' are scattered around site and not location in one area.
This screenshot shows the options we have set on all UPS'
UPS' affected:
Smart-UPS 2200 x3
Smart-UPS 3000
I'm not too sure where to go with this. I've done a bit of Googling and have checked various options in UPS Management and in Struxureware and can't see why this would be sending these alerts.
Any ideas would be greatly appreicated.
Thanks Forum 🙂
Accepted Solutions
Link copied. Please paste this link to share this article on your social media post.
Good Morning Dale,
Im sorry your getting that many emails. After looking over the interface there may be another location that you need to turn off the email alerts.
Check under Administration -> By Event -> Input Line Status, Then click on "UPS: Compensating for a high input voltage."
Click on Power events and then CTRL + F to find "High Input"
Make sure that is also turned off and let me know what you find.
Tom
Link copied. Please paste this link to share this article on your social media post.
Good Morning Dale,
Im sorry your getting that many emails. After looking over the interface there may be another location that you need to turn off the email alerts.
Check under Administration -> By Event -> Input Line Status, Then click on "UPS: Compensating for a high input voltage."
Click on Power events and then CTRL + F to find "High Input"
Make sure that is also turned off and let me know what you find.
Tom
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.