Launch of Consumer/Home Owner registration process!
We are pleased to announce the commencement of the Consumer/Home Owner Registration Process on Community. Consumers/Home Owners may now proceed to register by clicking on Login/Register. The process is straightforward and designed to be completed in just a few steps.
Firmware for SRT3000
APC UPS Data Center & Enterprise Solutions Forum
Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.
Search in
Improve your search experience:
Exact phrase→Use quotes " "(e.g., "error 404")
Wildcard→Use * for partial words(e.g., build*, *tion)
AND / OR→Combine keywords(e.g., login AND error, login OR sign‑in)
Keep it short→Use 2–3 relevant words, not full sentences
Filters→Narrow results by section(Knowledge Base, Users, Products)
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2023-04-1702:26 AM
Firmware for SRT3000
I have purchased a number of Smart-UPS SRT 3000 (Model: SRT3000RMXLI) in recent years (from 2019-2023).
Recently, the UPS purchased in 2019 has started to notify me to replace the battery while the battery status is healthy.
I want to set the Battery Health Alarm Warning Time to -1 to disable the notification warning but I cannot set in both LCD Console and Web. However, I can set the warning time for the UPS purchased in 2023.
After comparing the UPS in 2019 and 2023, I found that the old UPS is using firmware 5.3 (ID1010) and the new UPS is using firmware 8.2 (ID1025).
It seems that firmware 8.2(ID1025) has solved this issue. But I cannot find the firmware from the APC supporting page.