Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-07-0805:23 AM. Last Modified: 2024-02-1512:20 AM
Draw by outlet.
I have 2 of the same UPS with similar loads. I was getting the error on one of the logs stating output load threshold exceeded. I swaped the two units and I am getting that same error again on the other unit. So, I would like to narrow it down to device. My question is, is there a way to see the output to each of the outlets on the device.