APC UPS Data Center & Enterprise Solutions Forum
Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-30 12:41 AM . Last Modified: 2024-03-11 03:42 AM
The scenario I have experienced for a long time is the following. There is a power outage at a remote site. Network connectivity is maintained. My email is overloaded with repetitive messages, ex: UPS on battery due to distorted input. The same message is sent every few minutes until the UPS shuts down or power is restored. In this scenario, all I want to know if when the UPS goes on battery and when operation returns to normal. Is there a way to eliminate the repetitive notifications in between?
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-30 12:41 AM . Last Modified: 2024-03-11 03:42 AM
Hi,
Open the NMC web interface and go to Configuration - Notification - Event Actions and depending on how you have the NMC configured open by event or by group. If set up for e-mail by group open the groups select the recipient and deselect repeat interval.
If configured by event you will go to Configuration - Notification - Event Actions - Events select the event and then the recipient and deselect repent interval.
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-30 12:41 AM . Last Modified: 2024-03-11 03:42 AM
Hi,
Open the NMC web interface and go to Configuration - Notification - Event Actions and depending on how you have the NMC configured open by event or by group. If set up for e-mail by group open the groups select the recipient and deselect repeat interval.
If configured by event you will go to Configuration - Notification - Event Actions - Events select the event and then the recipient and deselect repent interval.
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.