Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

Close
Important Announcement: WELCOME to the new Schneider Electric Community! Community is now no longer part of Exchange, and is now rebranded under se.com. If you have any bookmarks and links saved, we request you to update them to ensure that you continue accessing our community from this new location. For any issues that you might encounter as part of this change, please reach out to SchneiderCommunity.Support@se.com, and the team will help to get your issues resolved.
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
82456members
350007posts

UPS SURT10000XLI doesn't work!

APC UPS Data Center Backup Solutions Forum

Schneider Electric support forum for Data Center UPS, software and services including our APC offers designed to share knowledge, installation, configuration, and general product use.

Solved
kiba_apc
Cadet
0 Likes
1
241

UPS SURT10000XLI doesn't work!

This was originally posted on APC forums on 10/6/2016


I replaced the batteries, after that, The UPS shows me the following message:

Errot

Please I don't know What Happened!

Attachments

Accepted Solutions
MarkC_apc
Commander
Commander
0 Likes
0
241

Re: UPS SURT10000XLI doesn't work!

This was originally posted on APC forums on 10/6/2016


The red LED indicates an internal fault in the UPS.  The third from the top green LED indicates that the problem is in the power factor correction portion of the UPS.  This is not user fixable.  If under warranty, contact Schneider.  

However, since it appears to be related to a battery replacement, you should ensure that the four battery cages are in good condition, fully charged and properly connected.  

See Answer In Context

1 Reply 1
MarkC_apc
Commander
Commander
0 Likes
0
242

Re: UPS SURT10000XLI doesn't work!

This was originally posted on APC forums on 10/6/2016


The red LED indicates an internal fault in the UPS.  The third from the top green LED indicates that the problem is in the power factor correction portion of the UPS.  This is not user fixable.  If under warranty, contact Schneider.  

However, since it appears to be related to a battery replacement, you should ensure that the four battery cages are in good condition, fully charged and properly connected.