How to set Multiple MTN6303-0019 as Master and Slaves

[IC_Systems]

Hello Dears,

How to correctly set Multiple MTN6303-0019 one as Master and others as Slave?

I set the slave input as active for the master and link it with the switch output from the other slaves; but it didn't functioning well!

[Thomas_Rohde · Accepted solution]

Hello IC_Systems,

please take a look at the following picture.
I guess it makes it very clear how to set it up.

[IC_Systems]

Thank you @Thomas_Rohde ,

So to get the most similar to the master slave in the ARGUS motion detector the slave input should be set to (ON). Right?

thank you for this conclusion @Thomas_Rohde 

[Thomas_Rohde]

Hello IC_Systems,

Yes correct. But at the end ... it is a question of taste. Because with both variants you will make it work.

[ikosi]

did you put one group address from master swtich output to start the light, and secon group adress for slave input and other slawe sitich output?

thx

[IC_Systems]

hello @ikosi 
use one GA for Slave and Master and the other one for the light/switch

this is how I make it.

[ikosi]

thx, I have 5 slaves , and i put all 5 in same group address is that ok?

this is setting for master

this is settings for all slaves

group address for slave

thx for help