Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel

RTU Modbus difference between PM5110 and PM5350

Remote Operations Forum

Collaborate and share knowledge on the extensive range of remote systems and devices, including SCADA radios and RTUs, on the Schneider Electric Exchange Remote Operations (formerly SCADA & Telemetry) forum. From commissioning SCADA integration devices and software, to enhancing existing installations or troubleshooting, connect with a global community of experts and users. Subscribe today.


RTU Modbus difference between PM5110 and PM5350

Good Day Everyone!

I have some problem to read Modbus registers over RTU mode. I believe there are a lot of expert in this community. I will be grateful if you help me how to sort out this problem. 


My objective is to read the current and voltage data using raspberry pi 4. I develop one code which make the raspberry pi4 to communicate with power meter using Modbus over RTU. I successfully manage to read the data using Schneider power meter (PM5350) but when I use Schneider power meter (PM5110) it fail. I saw the registers for both of power meter is same but still I cannot get the data from PM5110. I already check the wiring connection, baud rate and address. Everything is good but still I cannot get the data from the power meter.

Another curiosity is that every model have different offset of registers? If do so how to know about the offset?


Thank You. 

Tags (1)