DNP3 Backfill Trend functionality using a SCADAPack 350e and EPO

[Tabs]

Hello everyone,

I'm wondering if anyone has experience with enabling the DNP3 backfill trend in power operation webhmi. 

I've attached screenshots of my Citect.ini parameter settings for DNPR and Trend, Scadapack event settings and point properties and the actual trend display after reconnecting between EPO and SCADAPack 350e.

I'm facing an issue where it always shows a straight line to the current value when reconnected instead of the manually drawn blue line between the disconnection time in yellow highlight . (trend display image). 

Any insights or advice would be greatly appreciated. Thank you.

[sbeadle · Accepted solution]

Please post your question to the EPO forum: https://community.se.com/t5/EcoStruxure-Power-Operation/bd-p/power-scada-operation