Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84539members
353793posts

iEM 3255 Digital Input

Metering & Power Quality

Collaborate with multiple experts and discuss various topics about Power Meters and Power Quality. From design & implementation to troubleshooting and more, get support from experts and share your experiences by subscribing to the Schneider Electric Exchange forum today.

luis_dias_emr_p
Lieutenant | EcoXpert Master Lieutenant | EcoXpert Master
Lieutenant | EcoXpert Master
0 Likes
3
241

iEM 3255 Digital Input

Dear Sir's


I want to count pulses from a sensor with the iEM3255 Digital Input available in this meter.


I would like to know how many pulses can I count every second?

I check everywhere but I don´t find this information!

If someone can give me this information I will appreciate,

Thanks very much,

Best Regards,

Luís Dias

3 Replies 3
sesa388358
Schneider Alumni (Retired)
Schneider Alumni (Retired)
0 Likes
0
206

Re: iEM 3255 Digital Input

Hello Luis,

The following infomation was found on the PM3200 series user manual.

Capture.JPG

Best luck to you,

Niara

ChenLiang
Schneider Alumni (Retired)
Schneider Alumni (Retired)
0 Likes
1
206

Re: iEM 3255 Digital Input

Hello Luis,

iEM3000 has 4 DI functions of Digital Input:input status,input metering,tariff control and partial reset. For your application, you need to set the DI function to "input metering": the meter counts and records the number of incoming pulses. And you must also configure "In.Pulse constant",to indicate how many units each incoming pulse represents. More information please refer to the user manual:  http://www2.schneider-electric.com/resources/sites/SCHNEIDER_ELECTRIC/content/live/FAQS/239000/FA239...

Hope it helps

Leo

JoanBMS
Crewman
Crewman
0 Likes
0
199

Re: iEM 3255 Digital Input

Hi.

 

We need to know how we can visualize this register. A mean, we can read it via MODBUS, but isn't clear if we can see it on the display. Can be this possible??