Schneider Electric support forum about Power Meters (ION, PowerTag, PowerLogic) and Power Quality from design, implementation to troubleshooting and more.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
2022-07-1804:46 AM
SLPSLXX needs a modbus line terminator?
I´m working in a project for BMS, where many SLPSLXX are used. Those sensor are coneccted in a modbus net to the RP-C, via sensor bus port. I know that all the modbus lines needs at both ends a 120 ohm resistor, but I didn´t find any document about how to do it on this system.
I would be grateful if someone could confirm if I need the bus end resistor or not.