Schneider Electric support forum about Power Meters (ION, PowerTag, PowerLogic) and Power Quality from design, implementation to troubleshooting and more.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
2017-05-1706:17 AM
ION8650A Firmware/Framework issues
Hello Guys,
A couple of years back we prepared a customized framework for a customer under V405 firmware version. Since the new meters with new firmware arrived to the customer, they were unable to use the customized framework in the new meters because the meter stays without "enough processing power". We downgraded the new meters to the old firmware we used to develop the customized framework (V405) and they work ok with the customized framework (real time, calculus, data recordings and almost everything is ok) BUT they shown nothing on each display configured in the meters, just empty displays and some horizontal lines are shown. We tried to update the framework for the actual firmwares (that seems to be more intensive) but the meter stays always without enough processing power to complete all the required tasks for the customized framework (even for firmwares 4.07 and up). Any help please?.