Subscribing is a smart move!
You can subscribe to this board after you log in or create your free account.
[ION7650&PM8240] IEC 61850 timestamp issue of sag/swell event
Metering & Power Quality
Schneider Electric support forum about Power Meters (ION, PowerTag, PowerLogic) and Power Quality from design, implementation to troubleshooting and more.
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Solved
Go to Solution
Link copied. Please paste this link to share this article on your social media post.
Hi, all.
I have some problem a IEC 61850 of ION7650 and PM8240 meter.
I have to transfer Sag/Swell data to SCADA system using IEC 61850 protocol. (upload CID file to meter)
When it occurred Sag/Swell, it is display millisecond unit about event occurrence time in PME.
But when I read the timestamp of sag/swell parameter of event data from meter using iec client (ex. IECViewer and SCADA),
it was display only seconds unit in IECViewer and SCADA system.
I have to send the Sag / Swell occurrence time in milliseconds to the SCADA system.
How can I fix it?
Accepted Solutions
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.